Type .005 DA-2C

Atmospheric, 2 Compartments, Steel


Type .005 DA-2C atmospheric deaerators are recommended for high-pressure boiler applications. The standard .005 design removes dissolved oxygen to a maximum level of .005 cubic centimeters per liter of feed water. Two-compartment design is typically used:

  • on systems having more than 20% return hot condensate
  • where floor space may not be sufficient for a two-tank design
  • when a complete, factory-packaged unit is preferred instead of field wiring and piping of freestanding surge tank and deaerator

The two-compartment design enables the flash steam that escapes the deaeration compartment to be recovered by the direct contact vent condensor in the accumulator compartment. This method allows minimal vent loss.

Standard deaerator receivers available in black steel. The complete unit can be plasite-lined or made of 300 series stainless steel. Unit can built to handle a wide range of flows and pressures; receiver can be customized in terms of diameter, length and height to meet job specific requirements.

Number of pumps on unit depends upon number of boilers to be supported and stand-by specifications. Pump motors can be either 1750 RPM or 3500 RPM, single or three phase. Unit equipped with single stage or multi-stage pumps depending upon operating conditions. Pumps bronze-fitted with industry standard motors and mechanical seals rated for temperatures up to 300°F. Higher temperature seals and special faces available upon request. Pumps can be mounted in either a vertical or horizontal orientation.

Unit equipped with direction steam injection assembly with stainless steel preheat tube; assembly includes temperature regulator that can be either pneumatic controlled or self-contained. Other accessories include but not limited to gauge glass assembly thermometer, inlet strainer, butterfly isolation valve, low-water cut-off or alarm switch, electrical control panels and tank insulation.